Demo site by Demand & ConvertWant a website like this? Get a free website + a 60-day free Local SEO trial.Get my free website

Why LED Bulbs Flicker on a Dimmer, and How to Fix It

Steve Chhay Switchplate Home Electric

3 min read

Updated:

You change your old bulbs for LEDs and the lights start to flicker, buzz or glow faintly when they should be off. The bulbs are probably fine. The usual cause is a mismatch between the bulbs and the dimmer on the wall. Here is how to work out what is going on.

Why the old dimmer struggles

Older dimmers were made for incandescent bulbs, which draw a lot of power. An LED bulb gives the same light with a small fraction of that power. Many older dimmers need a minimum load to work properly, and a few LED bulbs may not reach it. The dimmer then behaves in odd ways.

What a mismatch looks like

  • Flickering, mostly at low settings
  • A buzz or hum from the bulbs or from the dimmer
  • Lights that jump from off to fairly bright with nothing in between
  • Lights that cut out before the slider reaches the bottom
  • A faint glow that stays when the dimmer is off

Check the bulbs first

Not every LED bulb can be dimmed. Look at the base of the bulb or the box for the word dimmable. A bulb that is not made for dimming will flicker or fail early on any dimmer, and the fix is simply a different bulb.

Use the same bulb in every socket on one dimmer. Mixing brands, or mixing LED bulbs with older types, often causes uneven dimming.

Then check the dimmer

Look for a dimmer that is made for LED loads. The packaging will say so. Many bulb and dimmer makers also publish lists of products that have been tested together, and it is worth a look before you buy.

Pay attention to the rating. A dimmer has one limit for incandescent bulbs and a lower limit for LEDs. Add up the watts of all the bulbs it controls and stay within the LED figure.

The small adjustment many people miss

Many LED dimmers have a small dial or lever hidden behind the wall plate or on the side of the switch. It sets the lowest level the dimmer will go to. If your lights flicker or drop out at the bottom of the range, raising this setting a little often cures it. The instructions that came with the dimmer explain how.

Switches at both ends of a hall or stair

When two switches control the same lights, the dimmer has to be a type made for that arrangement, and normally only one of the two positions gets the dimmer. Putting a standard dimmer at each end does not work.

Smart dimmers

Many smart dimmers need a neutral wire in the switch box. Some older houses do not have one there. Find this out before you buy, because it decides which models you can use.

When the dimmer is not the cause

Sometimes flickering has nothing to do with dimming. Take note if any of these are true:

  • Lights flicker on circuits with no dimmer at all
  • Lights across the whole house dim when a large appliance starts
  • The dimmer or its plate feels hot, not just slightly warm
  • You hear crackling, or smell something burning, at the switch

These point to a loose connection or a problem at the panel or the service to the house. Stop using the switch, turn off its breaker if you can do so safely and call an electrician.

A simple order to try things in

  • Confirm the bulbs are dimmable and all the same
  • Check the dimmer is made for LED bulbs and is within its rating
  • Adjust the low-end setting if the dimmer has one
  • If it still flickers, have the wiring checked

If you would like help choosing and fitting the right dimmers, call Switchplate Home Electric. We test the bulbs and dimmers together, replace what does not match and leave the plates straight.

Not sure which breaker does what?

Tell us about your panel and we will help you sort it out.

Request a Visit(614) 555-0129 or send us the details
Call